Titanium and Titanium Alloy Wire Drawing Process

Jan 21, 2026

Leave a message

Titanium and titanium alloy wires are widely used in many fields such as aerospace, petrochemicals, healthcare, automotive, construction, and sports and leisure products. Currently, more than 80% of titanium and titanium alloy wires are used as welding wires; they can be woven into meshes for seawater filtration, purified water filtration, chemical filtration, etc.; used to manufacture fasteners, load-bearing components, springs, and more; used in medical devices, such as dental crown fixation and cranial fixation implanted in the human body; titanium-nickel alloy wires are used to make satellite antennas, eyeglass frames, and more; in the electroplating and water treatment industries, titanium and titanium alloy wire drawing processes are employed.

The wire drawing of titanium and titanium alloy involves pulling coils or wire blanks through the die hole of a wire drawing die under the action of drawing force to produce titanium and titanium alloy wires of small cross-sections, which is a metal plastic processing process. There are several types of drawing processes:

 

Titanium white filaments Large in number                        Titanium white filaments Good quality

 

(1) Fixed die drawing: Fixed die drawing is one of the main production processes for metal wires. The materials used for drawing dies mainly include hard alloys, natural diamonds, synthetic diamonds, and polycrystalline diamonds. Single-crystal natural diamond dies are commonly used in the production of fine wires.

 

(2) Roll Die Drawing: Since roll die drawing is performed in a die hole composed of non-driven, freely rotating rollers, the sliding friction between the material and the die hole during fixed die drawing is converted into very small rolling friction, significantly reducing drawing friction. The drawback of roll die drawing is that its dimensional accuracy is not as high as that of fixed die drawing. It is suitable for coarse wire drawing, while fixed die drawing is used for finishing in fine wire drawing.

(3) Ultrasonic Vibration Drawing: This method was developed in the 1950s. During drawing, ultrasonic vibrations are applied to the drawing die, which can effectively reduce the drawing force and improve the processing rate per pass.

(4) Die-less Drawing: This process uses induction coils or lasers to locally heat and soften the wire, then applies tension to reduce the wire diameter. Its advantages are that no drawing die or lubricant is needed, the deformation rate is high, and efficiency is high. The drawbacks are poor uniformity in finished product dimensions and unstable quality.

(5) Pressurized Die Drawing: This process involves installing a pressurization nozzle device in front of the drawing die. During wire drawing, it achieves automatic pressurized forced lubrication. Its advantages include reducing wire breakage frequency by 4/5, increasing die life more than 20 times, and improving surface quality.

(6) Coating-Sleeve Bundle Drawing: In this method, a layer of low-carbon steel is first plated on the surface of titanium wire. The plated titanium wires are then bundled and inserted into a low-carbon steel tube. Bundle drawing is carried out with intermediate annealing. After reaching the final size, the low-carbon steel sleeve and coating are removed by sulfuric acid pickling. Its advantages are high efficiency and low production cost.

(7) Sleeve-Fragment Extrusion: Developed by Tohoku University in Japan, this process is mainly used for processing TiNi shape memory alloy wires, improving product quality and reducing production costs. Multilayer composite sheets are first prepared by clad rolling using metal sheets of different materials, with the thickness ratio of various metal layers determined by the specified chemical composition. The rolled sheet is cut into fragments, which are filled into a container to form billets. The billets are extruded into rods, then further processed into fine wires. Finally, heat diffusion treatment transforms the composite wires into the desired intermetallic compound wires.

(8) Four-Roll Wire Rolling Mill for Continuous Wire Production: This rolling mill consists of four rollers forming a circular die, with one driving roll rotating the other three rolls during operation. Multiple such frames form a continuous rolling unit for producing titanium alloy wire, significantly improving wire productivity and yield.

Send Inquiry